HELIX M FOUR 4-CHANNEL AMPLIFIER

  • Small footprint Class D amplifier with a high output power of 100 Watts RMS @ 4 and 2 Ohms load
  • Start-Stop capability down to 6V supply voltage
  • Auto Turn-On function
  • Integrated, active crossover with highpass, lowpass and bandpass
  • Exclusive, extremely compact and clean design with illuminated HELIX-logo 
SKU: M FOUR

$599.00

Description

HELIX M FOUR

4-CHANNEL AMPLIFIER

100WATTS RMS x 4

If you like to rev up your front and rear speakers, the Helix M FOUR will be exactly the right "tool" to do so. With generously 100 Watts RMS per channel into both 4 Ohms and 2 Ohms load this amp will heat up your voice coils in no time despite its super-compact dimensions. On the other hand, the M FOUR stays totally cool thanks to the highly efficient Class D design topology. 3-channel or 2-channel configurations are possible as well, delivering up to 2 x 200 Watts RMS of clean and undistorted output power.

HELIX-M-FOUR_Front-side-inputs_1200x630_SoundGarageQLD

[/caption]
Needless to say that the M FOUR is equipped with a bunch of intelligent attributes like "start-stop capability" and our proprietary "ADEP" high-level input so that it easily deals with all installation challenges of modern cars. Finally, the extensive audio features will offer sound quality at its best.

HELIX-M-FOUR_Front-side-outputs_1200x630_SoundGarageQLD

Smart high-level input

The latest generation of OE car radios incorporates sophisticated possibilities for diagnosing connected speakers. If a common amplifier is hooked up failure messages and loss of specific features (e.g. fader function) often appear - but not with the M FOUR.
The new ADEP circuit (Advanced Diagnostics Error Protection) avoids all these problems without unnecessarily loading the OE radio speaker outputs during high volumes.

Start-Stop capability

The switched power supply of the HELIX M FOUR assures operation even if the battery’s voltage drops down to 6 Volts during engine crank.

Scope of delivery

1 x Amplifier HELIX M FOUR
1 x Mounting material
1 x Instruction manual

 
  • Small footprint Class D amplifier with a high output power of 100 Watts RMS @ 4 and 2 Ohms load
  • Start-Stop capability down to 6V supply voltage
  • Smart high-level input with ADEP circuit (Advanced Diagnostics Error Protection) and Auto Turn-On function
  • Integrated, active crossover with highpass, lowpass and bandpass
  • “Input mode” switch for flexible input signal routing
  • SMD (Surface Mounted Device) manufacturing technology combines minimum space requirements with maximum reliability
  • Exclusive, extremely compact and clean design with illuminated HELIX-logo and low heat dissipation thanks to extraordinary efficiency

Technical data

Output power RMS  ≤ 1% THD+N  
- @ 4 Ohms 4 x 100 Watts
- @ 2 Ohms 4 x 100 Watts
- @ 1 Ohm -
- bridged @ 4 Ohms 2 x 200 Watts
- bridged @ 2 Ohms
Max. output power per channel* Up to 135 Watts RMS @ 4 / 2 Ohms
Amplifier technology Class D
Inputs 4 x RCA / Cinch
4 x High-level speaker input
1 x Remote In
Input sensitivity RCA / Cinch 0.5 - 6 Volts
High level 1.3 - 13 Volts
Input impedance RCA / Cinch 20 kOhms
Input impedance highlevel 9 - 33 Ohms
Outputs 4 x Speaker output
Output voltage RCA / Cinch
Signal converter for digital input
Frequency response 10 Hz - 30,000 Hz
Bass boost
Highpass 15 Hz - 4,000 Hz adjustable
Lowpass 40 Hz - 4,000 Hz adjustable
Bandpass 15 Hz - 4,000 Hz adjustable
Subsonic
Phase
Slope high- / lowpass 12 dB/Oct.
Slope subsonic / lowpass
Signal-to-noise ratio digital input
Signal-to-noise ratio analog input 98 dB (A-weighted)
Distortion (THD) 0.05 %
Damping factor 100
Operating voltage 10.5 - 16 Volts (max. 5 sec. down to 6 Volts)
Idle current 1,100 mA
Fuse 2 x 30 A Maxi-fuse (APX)
Additional features Active, adjustable crossover, input mode switch, Start-Stop capability, high-level input with automatic turn-on function and Advanced Diagnostics Error Protection (ADEP)
Dimensions (H x W x D) 50 x 230 x 154 mm /
2.00 x 9.06 x 6.06”

* In typical multi-channel applications (2- / 3-way system + rear + subwoofer)

 

Reviews

There are no reviews yet.

Be the first to review “HELIX M FOUR 4-CHANNEL AMPLIFIER”

Your email address will not be published. Required fields are marked *

related products that fit your ride
Alpine RUX-H01 Halo Design Remote Bass Knob for use with Alpine Amplifiers
VIEW PRODUCT >
Alpine TMX-R3200SE 10.2" Overhead Monitor
VIEW PRODUCT >
Mongoose MPR-S - REAR PARKING SENSORS (BLACK)
VIEW PRODUCT >